• Introduction
• How to work
• Installation
• Maintenance
• Cases

How to achieve impact crushers run debugging ?

Pay special attention to the following problems in the working process of single-stage impact crushers:Impact Crushers bearing temperature is too high.  Detailed troubleshooting:  To check whether the Impact Crushers grease is reduced; The grease should be filled with 50% of the Impact Crushers bearing capacity according to standard;To timely clean Impact Crushers bearings and replace grease; Replace Impact Crushers badly worn bearings.

The Impact Crushers crushing chamber produces very intense percussion during operation.Immediately shut down power, stop Impact Crushers machine and clean up the crushing chamber; check whether there exists materials that cannot be broken in the Impact Crushers crushing chamber. check the Impact Crushers fastening situation, the gap between hammer and lining and whether the resistant liner drops. Replace Impact Crushers fractured parts.

Impact Crushers material particle size is too large in the discharging process.Adjust the Impact Crushers gap between front and back impact plats or replace the badly worn liner and plate hammer;  Adjust the Impact Crushers position of impact plate; keep both sides can be achieved relative  gap with the rack to ensure the material particle size.

Thank you for your interest in YiFan. Please use any of the methods below to get in touch with us.
Add: The Middle of Zhengyuan Road, Xingyang Eastern Development Zone.
zip:450100
E-mail：yifanseo@yfmac.com
MSN On line: yifancrusher@yahoo.cn
ICQ: 639607958 QQ: 2502761202
Tel: +86-371-64628852 Fax: +86-371-64628872
The article by Vertical Shaft Impact Crusher,Impact Crushers Yifan Machinery Editor: http://www.impactcrushers.org/, please indicate the source , little effort , thank you .